Konzept eines Levitations-Konverters

VB-FluxLev-EMDR-Konverter-450x641-jpgVB-FluxLev-EMDR-Konverter-Kuppel-450x641-jpgDas Konzept eines Levitations-Konverters nimmt langsam Gestalt an. Da es in der VisionBlueEnergy Facebookgruppe eine Diskussion zur der Problematik gab, ob der magnetische Rotor nicht nach oben ausbrechen könnte, überlegen wir, ob wir der Konstruktion noch eine Art Kuppel aufsetzen, in denen montierte Magneten den Gegendruck nach unten gewährleisten. Diese Kuppel könnte auf Gewindestangen, die auch mit dem Stator verankert werden müssen, aufmontiert werden. Die Höhe der Kuppel ließe sich dann mittels aufgeschraubter Muttern genau einstellen, dass der Gegendruck von oben den Rotor im Stator schweben lässt ohne dass er nach oben ausbrechen kann.

Die im System verwendeten Spulen haben keinen Spulenkern, wodurch die Flussfrequenzen keinerlei Begrenzung unterliegen. Wir haben bereits solche Spulen erfolgreich getestet, was im folgenden Video ersichtlich ist:

Auch die Levitation eines horizontal magnetisch gelagerten Systems haben wir bereits getestet und herausgefunden, dass die Reibungsverluste durch die verringerte Gravitation des Rotors exorbitant sinken. Dies ist aus folgendem Video ersichtlich:

Die Levitaion wird dadurch erzielt, dass die Magneten im Rotor alle nach außen in der gleichen Polarität wie die Magneten am Stator ausgerichtet werden, damit es eine Abstoßung gibt. Das System läuft also im Monopolmodus. Die dargestellte Schaltung ist nur vorläufig.

Englisch:

The concept of a levitation converter is slowly taking shape. Because there was a discussion in the VisionBlueEnergy Facebook group about the problem of whether the magnetic rotor could not break up, we think about adding a kind of dome to the design, in which mounted magnets ensure counterpressure down. This dome could be mounted on threaded rods, which also need to be anchored to the stator. The height of the dome could then be precisely adjusted by means of screwed-on nuts that the back pressure from above allows the rotor to float in the stator without it being able to break up.

The coils used in the system do not have a coil core, which means that the flux frequencies are not limited. We have already successfully tested such coils, as shown in the following video:

https://www.youtube.com/watch?v=2HDRm4X4sg8
We have already tested the levitation of a horizontal magnetically levitated system and found that the friction losses due to the reduced gravitation of the rotor are exorbitant. This is evident from the following video:
https://www.youtube.com/watch?v=gROYyqOVnMA
The levitation is achieved by aligning the magnets in the rotor all outwards in the same polarity as the magnets on the stator so that there is a repulsion. So the system runs in monopole mode. The circuit shown is only preliminary.

Rechtlicher Hinweis:
Alle abgebildeten Zeichnungen unterliegen dem Copyleft des jeweiligen Urhebers. Die uneingeschränkten Nutzungsrechte liegen beim Vision Blue Energy e.V. Bad Liebenstein und des Vision Blue Förderverein e.V. Eisenach. Die Nutzung und Weiterentwicklung der Darstellungen wissenschaftlicher und technischer Art ist erlaubt soweit hieraus keine kommerzielle Nutzung hervorgeht. Eine kommerzielle Nutzung bedarf in jedem Falle des Einverständnisses des Vision Blue Energy e.V.!

Disclaimer:
All blueprints are subject to copyleft of the respective author. The unrestricted use rights are with the Vision Blue Energy Association e.V. Bad Liebenstein and the Vision Blue Förderverein e.V.. The use and further development of the representations of scientific and technological kind is allowed provided that these shows not for commercial use. Any commercial use requires permission of the Vision Blue Energy Association.

ACHTUNG:
DIE VERWENDUNG ALLER KONSTRUKTIONSPLÄNE UND SKIZZEN ERFOLGT AUF EIGENE GEFAHR! DIE URHEBER HAFTEN WEDER FÜR ETWA FEHLENDE FUNKTIONSFÄHIGKEIT NOCH FÜR SCHÄDEN!

CAUTION:
USING OF ALL CONSTRUCTION PLANS AND SKETCHES IS YOUR OWN RISK! THE AUTHORS ARE NOT BE LIABLE FOR ANY MISSING FUNCTIONALITY OR FOR ANY DAMAGE!

Kommentar verfassen